Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017078 2NZ-FE EMISSION CONTROL _0092333 EMISSION CONTROL SYSTEM G

2NZ-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT OPERATION

a.

Start and warm up the engine.


b.

Open the throttle valve and keep the engine speed at 3500 rpm.


c.
A281746C01
0.719,1.563 1.094,0.833 true 0.531,1.479 0.844,1.635 0.313,0.156 10 false *a
*a Sound Scope


Use a sound scope to check for injector operating sounds.


d.

Check that when the accelerator pedal is released, injector operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel injection restart engine speed 1400 rpm


If the result is not as specified, check the fuel injector assemblies, wire harness and ECM.


Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Inspect the hoses and gaskets for scratches, cracks and air/oil leaks from the connecting parts.

NOTICE:

If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.



Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Start the engine.


b.
A300014

Loosen the hose clip and disconnect the fuel vapor feed hose assembly from the purge VSV.


c.

Connect the GTS to the DLC3.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VSV for Evap Control
50004 234 6

f.

Check that a vacuum occurs at the purge VSV port.


g.

If vacuum does not occur, check the following items.

·

Purge VSV (for canister purge)

·

Clogging in the fuel vapor feed hose assembly connecting the intake air surge tank and purge VSV

·

Voltage from the ECM PRG terminal



h.

Exit the Active Test mode and reconnect the fuel vapor feed hose assembly to the purge VSV with the hose clip.


i.

Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

Powertrain > Engine and ECT > Data List
Tester Display
EVAP (Purge) VSV
50003 234 31

j.

Warm up the engine and drive the vehicle.


k.

Confirm that the purge VSV opens.

If the result is not as specified, replace the purge VSV, wire harness or ECM.