Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › PURGE VALVE › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017078 2NZ-FE EMISSION CONTROL _0092335 PURGE VALVE G

2NZ-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

a.

Check the resistance.

i.
A302932C01
0.104,0.104 0.417,0.302 0.313,0.198 10 false *a 1.813,1.094 2,1.333 0.188,0.24 14 false 1 1.479,1.094 1.667,1.333 0.188,0.24 14 false 2
*a Component without harness connected
(Purge VSV)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge VSV.



b.

Check the operation.

i.
A302968C01
1.292,1.333 1.49,1.667 false 0.479,1.771 0.635,1.99 false 2.094,1.375 2.406,1.531 0.313,0.156 10 false *a 1.531,1.583 1.844,1.74 0.313,0.156 10 false *b 0.688,1.906 1,2.063 0.313,0.156 10 false *c
*a Air
*b Port E
*c Port F


Apply battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

OK:
Condition Specified Condition
Battery voltage applied to terminals 1 and 2 Air flows from port F.
Battery voltage not applied to terminals 1 and 2 Air does not flow.


If the result is not as specified, replace the purge VSV.