16520A
1.INSPECT WATER FILLER CAP SUB-ASSEMBLY
Visually check the water filler cap sub-assembly.
If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.
Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.
Check that rubber packings 3 and 4 are not stuck together.
If necessary, replace the water filler cap sub-assembly.
| *1 | Water Filler Cap Sub-assembly |
| *a | Radiator Cap Tester |
| *b | 30° or more |
Measure the valve opening pressure.
Apply engine coolant to rubber packings 2 and 3.
Install the water filler cap sub-assembly to the radiator cap tester.
Pump the radiator cap tester several times, and check the maximum pressure.
1 pump per second
Using the radiator cap tester, tilt it to more than 30 degrees.
Even if the water filler cap sub-assembly cannot maintain the maximum pressure, it is not a defect.
| Item | Specified Condition |
|---|---|
| Standard value
(for brand-new water filler cap sub-assembly) |
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi) |
| Minimum standard value
(after using water filler cap sub-assembly) |
78.5 kPa (0.8 kgf/cm2, 11.4 psi) |
If the maximum pressure is less than the specified pressure for the minimum standard value, replace the water filler cap sub-assembly.