28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly to the cylinder block sub-assembly and oil pan sub-assembly with the 2 bolts.
Connect the terminal 50 connector.
Connect the terminal 30 to the magnet starter switch assembly with the nut.
Close the terminal cap.
11363A
2.INSTALL FLYWHEEL HOUSING SIDE COVER
Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, fit the claw into the cylinder block sub-assembly.
Make sure that the claw makes a click sound, indicating that it fits tightly.
Replace the claw with a new one if it does not fit tightly or is deformed.
51405A
3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
4.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL