Home › Engine / Hybrid System › 2NZ-FE STARTING › STARTER › 2013.08–2016.07
RM30M0E _51 Engine / Hybrid System _017086 2NZ-FE STARTING _0092348 STARTER A

2NZ-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51451A 3.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 11363A 5.REMOVE FLYWHEEL HOUSING SIDE COVER

A305621

a.

Disengage the claw while pulling it upward and remove the flywheel housing side cover.


Hide 28100 6.REMOVE STARTER ASSEMBLY

A302884C02
0.844,0.979 1.104,0.542 true 0.677,0.885 0.99,1.042 0.313,0.156 10 false *1
*1 Terminal Cap


a.

Open the terminal cap.


b.

Remove the nut to disconnect the terminal 30 from the magnet starter switch assembly.


c.

Disconnect the terminal 50 connector.


d.

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly and oil pan sub-assembly.