1.REMOVE STEERING COLUMN ASSEMBLY (for LHD)
2.REMOVE STEERING COLUMN ASSEMBLY (for RHD)
69057A
3.REMOVE IGNITION SWITCH LOCK CYLINDER AND KEY SET (for LHD)
69057A
4.REMOVE IGNITION SWITCH LOCK CYLINDER AND KEY SET (for RHD)
84450
5.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY
Disengage the 2 claws to remove the ignition or starter switch assembly from the ignition switch lock cylinder and key set.
Perform this operation after situating the ignition switch lock cylinder and key set in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.
Do not turn the ignition switch lock cylinder and key set sideways or downward because doing so might release the ignition switch lock cylinder and key set's component parts.