Home › Power Source / Network › 2NZ-FE BATTERY / CHARGING › CHARGING SYSTEM › 2013.08–2016.10
RM30M0E _57 Power Source / Network _017108 2NZ-FE BATTERY / CHARGING _0092352 CHARGING SYSTEM L

2NZ-FE BATTERY / CHARGING  CHARGING SYSTEM  PRECAUTION  


IGNITION SWITCH EXPRESSIONS


a.

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch IG ON On (IG)
Engine Start START On (Start)



NOTICE:
·

Check that the battery cables are connected to the correct terminals.

·

Disconnect the battery cables when the battery is given a quick charge.

·

Do not perform tests with a high voltage insulation resistance tester.

·

Never disconnect the battery cables while the engine is running.

·

Check that the charging cable nuts are tightened on terminal B of the generator and on the engine room relay block and driver side junction block assembly.