Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING(for Sedan)
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092441 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75561 1.INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:

When installing new No. 1 roof drip side finish moulding clips, remove the double-sided tape remaining where the No. 1 roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with non-residue solvent.


a.
B229383
2.125,0.229 2.396,0.479 false 1.292,0.875 1.688,1.167 true 1.99,0.073 2.302,0.271 0.313,0.198 10 false *a 1.135,0.719 1.448,0.917 0.313,0.198 10 false *b
*a Adhesive
*b 2 to 3 mm bead of adhesive


Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive to 2 new No. 1 roof drip side finish moulding clips.

HINT:

Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1987 psi) or more (when the temperature is 23°C (73°F).)



b.
B342326
0.427,0.281 0.615,0.479 0.188,0.198 10 false A 1.063,0.26 1.25,0.458 0.188,0.198 10 false B 0.427,3.438 0.615,3.635 0.188,0.198 10 false D 1.063,3.469 1.25,3.667 0.188,0.198 10 false B 1.979,3.563 2.167,3.76 0.188,0.198 10 false C 2.5,3.427 2.688,3.625 0.188,0.198 10 false C 2.135,0.292 2.323,0.49 0.188,0.198 10 false C 2.667,0.323 2.854,0.521 0.188,0.198 10 false C

Install the 2 No. 1 roof drip side finish moulding clips to the positions on the vehicle body shown in the illustration. Determine the locations and firmly press and install the 2 No. 1 roof drip side finish moulding clips after lightly applying adhesive.

Standard Dimension
Dimension Measurement
A 3.1 mm (0.122 in.)
B 1.2 to 2.2 mm (0.048 to 0.086 in.)
C 4.0 mm (0.157 in.)
D 3.5 mm (0.138 in.)


c.

Install the roof drip side finish moulding when 20 minutes or more have elapsed after pressing and installing the 2 No. 1 roof drip side finish moulding clips.

HINT:
·

Initial hardening time: 20 minutes

·

Complete hardening time: 48 hours




Hide 75552E 2.INSTALL ROOF DRIP SIDE FINISH MOULDING

a.

Engage the 2 clips and install the roof drip side finish moulding.


b.

Remove the protective tape.