Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
75552E
1.REMOVE ROOF DRIP SIDE FINISH MOULDING
|
Protective Tape |
Apply protective tape to the vehicle body in the area around the roof drip side finish moulding.
Disengage the 2 clips and remove the roof drip side finish moulding.
Do not remove the No. 1 roof drip side finish moulding clips.
If any No. 1 roof drip side finish moulding clip is damaged or falls out, replace it with a new one.