Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT PILLAR UPPER COVER
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092443 FRONT PILLAR UPPER COVER A

EXTERIOR PANELS / TRIM  FRONT PILLAR UPPER COVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 60118 1.INSTALL FRONT PILLAR UPPER COVER SUB-ASSEMBLY

a.

Clean the attachment surface.

i.

Using an infrared light, heat the adhesive remaining on the vehicle body.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself with the vehicle body or infrared light.


NOTICE:

Do not heat the vehicle body excessively.



ii.

Using a piece of cloth, rub the remaining adhesive off the vehicle body.

NOTICE:

Remove any tape remaining on the vehicle body.



iii.

Using a non-residue solvent, clean the attachment surface.



b.
B340112
1.083,2.677 1.271,2.177 true 0.958,2.677 1.271,2.875 0.313,0.198 10 false *a
*a Double-sided Tape


Engage the claw and 2 clips, and install a new front pillar upper cover sub-assembly.

NOTICE:

Thoroughly press the front pillar upper cover sub-assembly to ensure that it adheres.


HINT:

Peel back the backing paper from the double-sided tape before installing the front pillar upper cover sub-assembly.



c.

Remove the protective tape.