Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT PILLAR UPPER COVER
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092443 FRONT PILLAR UPPER COVER A

EXTERIOR PANELS / TRIM  FRONT PILLAR UPPER COVER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 60118 1.REMOVE FRONT PILLAR UPPER COVER SUB-ASSEMBLY

a.
B342316
0,0 0.219,0 false
V100155

Protective Tape


Apply protective tape to the vehicle body in the area around the front pillar upper cover sub-assembly.


b.
B340111
1.031,2.677 1.271,2.177 true 0.906,2.677 1.219,2.875 0.313,0.198 10 false *a
*a Double-sided Tape


Using an infrared light, heat the vehicle body.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself with the heated vehicle body or infrared light.


NOTICE:
·

Do not heat the vehicle body excessively.

·

Remove any tape remaining on the vehicle body.




c.

Using a moulding remover, disengage the claw and 2 clips, and remove the front pillar upper cover sub-assembly while peeling off the double-sided tape.