Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE(for Center Pillar)
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092448 BLACK OUT TAPE(for Center Pillar) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Center Pillar)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75926B 2.INSTALL NO. 3 BLACK OUT TAPE

a.

Clean the attachment surface (Using an infrared light).

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION


b.

Clean the attachment surface (Using a tape removal disc).

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION


c.

Apply new No. 3 black out tape to the positions shown in the illustration.

B348882E01
1.156,1.021 1.313,1.219 0.156,0.198 10 false A 1.156,1.542 1.313,1.74 0.156,0.198 10 false A 1.188,2.073 1.344,2.271 0.156,0.198 10 false B 1.844,2.125 2,2.323 0.156,0.198 10 false B 4.5,0.333 5.271,0.531 0.771,0.198 10 false A - A 5.51,0.417 5.667,0.615 0.156,0.198 10 false a 4.5,1.948 5.271,2.146 0.771,0.198 10 false B - B 4.885,2.5 5.042,2.698 0.156,0.198 10 false c 6.156,2.469 6.313,2.667 0.156,0.198 10 false b

Standard Measurement
Dimension Measurement
a 0 to 1.0 mm (0 to 0.0393 in.)
b 11.0 mm (0.433 in.)
c 10.0 to 12.0 mm (0.394 to 0.472 in.)


d.

Remove the release paper and apply the No. 3 black out tape.