Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER(for Upper Side) › 2013.08–2018.01
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0092547 REAR SPOILER(for Upper Side) A

EXTERIOR PANELS / TRIM  REAR SPOILER(for Upper Side)  INSTALLATION  


PROCEDURE

Hide 76871 1.INSTALL REAR SPOILER

a.

Clean the attachment surface.

i.

Using an infrared light, heat the double-sided tape remaining on the vehicle body.

Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)


CAUTION:

Do not burn yourself on the hot vehicle body panel or with the infrared light.


NOTICE:

Do not heat the vehicle body excessively.



ii.

Using a piece of cloth, rub the remaining double-sided tape off the vehicle body while it is hot from the infrared light.


iii.

Using a non-residue solvent, clean the attachment surface.


iv.

On the vehicle body, coat the attachment surface for the rear spoiler with primer.

NOTICE:

Do not apply the primer too thickly.




b.

Peel off the backing paper of a new rear spoiler, and engage the 3 clips and install it using sufficient pressure.

NOTICE:

Install the rear spoiler after the primer has dried (approximately 3 minutes).



c.

Install the 4 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 64719A 2.INSTALL LUGGAGE COMPARTMENT DOOR COVER