Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
76916F
1.REMOVE FRONT SIDE MUDGUARD
Remove the 3 screws.
Remove the 9 retainers.
Using an infrared light, heat the vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not burn yourself on the hot vehicle body or with the infrared light.
Do not heat the vehicle body excessively.
| *1 | No. 1 Moulding Tape |
While pulling the front side mudguard from the side of the vehicle, disengage the 9 clips while peeling off the 2 No. 1 moulding tapes. Then remove the front side mudguard.
75895F
2.REMOVE NO. 1 MOULDING TAPE
| *A | for Front Side |
| *B | for Rear Side |
Remove the 2 No. 1 molding tapes.
76926D
3.REMOVE SIDE MUDGUARD PROTECTOR
Remove the side mudguard protector.