Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH › 2013.08–2016.04
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092616 HEADLIGHT DIMMER SWITCH G

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  INSPECTION  


PROCEDURE

Hide 84140 1.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (w/ Projector Headlight)

a.

Check the resistance.

i.
E223779
2.354,1.385 2.5,1.833 true 1.479,1.385 1.5,1.833 true 1.823,1.375 1.896,1.833 true 2.208,1.083 2.417,0.438 true 1.979,1.073 1.719,0.417 true 0.938,1.396 0.844,1.813 true 1.292,1.385 1.25,1.833 true 2.542,1.406 2.792,1.854 true 2.177,1.406 2.198,1.823 true 0.063,0.052 0.469,0.354 0.406,0.302 10 false *a 2.448,1.865 2.677,2.073 0.229,0.208 10 false EL 2.344,0.25 2.76,0.448 0.417,0.198 10 false LFG 1.854,1.854 2.135,2.083 0.281,0.229 10 false TL 1.198,1.854 1.51,2.104 0.313,0.25 10 false T 1.583,0.25 2.052,0.469 0.469,0.219 10 false BFG 0.792,1.844 1.104,2.115 0.313,0.271 10 false H 2.813,1.854 3.042,2.063 0.229,0.208 10 false HU 1.448,1.854 1.729,2.083 0.281,0.229 10 false HF 2.146,1.854 2.427,2.083 0.281,0.229 10 false TR
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 18 (T) OFF 10 kΩ or higher
12 (EL) - 18 (T) TAIL Below 1 Ω
12 (EL) - 18 (T) HEAD Below 1 Ω
18 (T) - 20 (H) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 17 (HF) HIGH FLASH Below 1 Ω
11 (HU) - 12 (EL) HIGH FLASH Below 1 Ω
11 (HU) - 12 (EL) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 13 (TR) OFF 10 kΩ or higher
12 (EL) - 15 (TL) 10 kΩ or higher
12 (EL) - 13 (TR) RH Below 1 Ω
12 (EL) - 15 (TL) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
4 (BFG) - 3 (LFG) OFF 10 kΩ or higher
4 (BFG) - 3 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.



Hide 84140 2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (w/o Projector Headlight)

a.

for LHD:

i.

Check the resistance.

1.
E218654
0.563,0.948 0.896,0.948 true 1.115,0.906 0.719,0.469 true 2.521,1.177 2.906,1.292 true 2.042,1.229 2.49,1.635 true 1.854,1.219 2.156,1.542 true 1.677,1.219 1.771,1.531 true 1.479,1.229 1.438,1.521 true 1.292,1.219 1.083,1.542 true 2.281,1.229 2.854,1.521 true 0.906,1.188 0.552,1.188 true 0.115,0.052 0.271,0.229 0.156,0.177 10 false *a 0.26,0.865 0.625,1.104 0.365,0.24 10 false LFG 0.406,0.344 0.833,0.594 0.427,0.25 10 false BFG 2.958,1.219 3.24,1.458 0.281,0.24 10 false TL 2.521,1.583 2.813,1.823 0.292,0.24 10 false E 2.094,1.573 2.438,1.833 0.344,0.26 10 false HL 1.677,1.573 1.99,1.771 0.313,0.198 10 false HU 1.344,1.552 1.635,1.844 0.292,0.292 10 false T1 0.99,1.542 1.302,1.76 0.313,0.219 10 false ED 2.896,1.531 3.208,1.813 0.313,0.281 10 false TR 0.292,1.115 0.573,1.354 0.281,0.24 10 false B1
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
10 (T1) - 11 (ED) OFF 10 kΩ or higher
10 (T1) - 11 (ED) TAIL Below 1 Ω
10 (T1) - 11 (ED) HEAD Below 1 Ω
13 (B1) - 11 (ED) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
8 (HL) - 11 (ED) HIGH FLASH Below 1 Ω
9 (HU) - 11 (ED) HIGH FLASH Below 1 Ω
9 (HU) - 11 (ED) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
6 (TR) - 7 (E) OFF 10 kΩ or higher
5 (TL) - 7 (E) 10 kΩ or higher
6 (TR) - 7 (E) RH Below 1 Ω
5 (TL) - 7 (E) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
3 (BFG) - 4 (LFG) OFF 10 kΩ or higher
3 (BFG) - 4 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.




b.

for RHD:

i.

Check the resistance.

1.
E223779
2.167,1.385 2.417,1.833 true 1.646,1.385 1.667,1.833 true 2.01,1.375 2.083,1.833 true 1.479,1.083 1.688,0.438 true 1.292,1.073 1.031,0.417 true 0.906,1.375 0.531,1.688 true 1.094,1.385 0.854,1.823 true 1.292,1.385 1.25,1.833 true 2.542,1.406 2.792,1.854 true 0.063,0.052 0.469,0.354 0.406,0.302 10 false *a 2.417,1.865 2.646,2.073 0.229,0.208 10 false T 0.875,0.25 1.292,0.448 0.417,0.198 10 false LFG 2.01,1.865 2.292,2.094 0.281,0.229 10 false HF 0.75,1.854 1.031,2.083 0.281,0.229 10 false EL 1.583,1.854 1.865,2.083 0.281,0.229 10 false TR 1.198,1.854 1.51,2.104 0.313,0.25 10 false TL 1.615,0.25 2.083,0.469 0.469,0.219 10 false BFG 0.323,1.688 0.635,1.958 0.313,0.271 10 false HU 2.813,1.854 3.042,2.063 0.229,0.208 10 false H
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.

If the result is not as specified, replace the headlight dimmer switch assembly.


Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 13 (T) OFF 10 kΩ or higher
19 (EL) - 13 (T) TAIL Below 1 Ω
19 (EL) - 13 (T) HEAD Below 1 Ω
13 (T) - 11 (H) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 14 (HF) HIGH FLASH Below 1 Ω
20 (HU) - 19 (EL) HIGH FLASH Below 1 Ω
20 (HU) - 19 (EL) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 16 (TR) OFF 10 kΩ or higher
19 (EL) - 18 (TL) 10 kΩ or higher
19 (EL) - 16 (TR) RH Below 1 Ω
19 (EL) - 18 (TL) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
7 (BFG) - 8 (LFG) OFF 10 kΩ or higher
7 (BFG) - 8 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.