Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092617 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.

Check the resistance.

i.
E136319C10
1.813,1.479 2.177,1.844 true 1.646,1.479 1.281,1.844 true 2.031,1.344 2.396,0.979 true 1.427,1.333 1.063,0.969 true 2.448,0.854 2.552,1.01 0.104,0.156 10 false E 0.844,0.854 1.26,1.104 0.417,0.25 10 false TB 1.063,1.875 1.469,2.073 0.406,0.198 10 false ILL+ 2.021,1.875 2.427,2.083 0.406,0.208 10 false ILL- 0.208,0.167 0.406,0.323 0.198,0.156 10 false *a
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (TB) - 1 (E) OFF 10 kΩ or higher
ON Below 1 Ω


If the result is not as specified, replace the hazard warning signal switch assembly.



b.

Check that the illumination lights.

i.

Apply battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.