Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092618 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.

Check the resistance.

i.
E272778C02
0.438,0.979 0.51,0.583 false 0.052,1.323 0.365,1.521 0.313,0.198 10 false *b 0.583,1.344 0.896,1.542 0.313,0.198 10 false *c 0.469,0.417 0.781,0.615 0.313,0.198 10 false *d 2.01,0.26 2.323,0.458 0.313,0.198 10 false *a
*a Component without harness connected
(Stop Light Switch Assembly)
*b Not Pushed
*c Pushed
*d Switch Pin


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 Switch pin pushed 10 kΩ or higher
Switch pin not pushed Below 1 Ω
3 - 4 Switch pin pushed Below 200 Ω
Switch pin not pushed 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.