Home › Vehicle Exterior › WINDOW / GLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0092742 FRONT PASSENGER SIDE POWER WINDOW SWITCH G

WINDOW / GLASS  FRONT PASSENGER SIDE POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810 1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.

Check the resistance.

i.
B345718C02
1.115,1.833 1.219,1.385 true 1.417,1.833 1.5,1.385 true 1.708,1.833 1.708,1.375 true 2.052,1.854 1.969,1.396 true 2.198,1.375 2.375,1.833 true 0.073,0.083 0.385,0.281 0.313,0.198 10 false *a 1.021,1.865 1.333,2.063 0.313,0.198 10 false SU 1.365,1.854 1.677,2.052 0.313,0.198 10 false U 1.677,1.854 1.99,2.052 0.313,0.198 10 false B 1.979,1.865 2.292,2.063 0.313,0.198 10 false SD 2.375,1.865 2.688,2.063 0.313,0.198 10 false D
*a Component without harness connected
(Power Window Regulator Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (D) - 2 (SD) UP Below 1 Ω
3 (B) - 4 (U) Below 1 Ω
1 (D) - 2 (SD) OFF Below 1 Ω
4 (U) - 5 (SU) Below 1 Ω
4 (U) - 5 (SU) DOWN Below 1 Ω
1 (D) - 3 (B) Below 1 Ω


If the result is not as specified, replace the power window regulator switch assembly.