Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER WIRE
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0092749 WINDOW DEFOGGER WIRE G

WINDOW / GLASS  WINDOW DEFOGGER WIRE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 64811 1.INSPECT REAR WINDOW DEFOGGER WIRE (BACK WINDOW GLASS)

NOTICE:
·

When cleaning the back window glass, wipe the back window glass along the wire using a soft, dry cloth. Take care not to damage the wires.

·

Do not use detergents or glass cleaners that have abrasive ingredients.

·

When measuring voltage, wrap a piece of aluminum foil around the tip of the negative tester probe and press the foil against the wire with your finger as shown in the illustration.



a.

Turn the ignition switch to ON (IG).


b.

Push the rear window defogger switch on.


c.

Check the voltage.

i.
B317108
0.531,3.573 0.792,3.177 false 2.417,3.438 2.677,3.042 false 1.677,4.198 1.938,3.802 false 0.792,3.031 1.104,3.229 0.313,0.198 10 false *a 2.688,2.896 3,3.094 0.313,0.198 10 false *1 1.552,4.208 1.865,4.406 0.313,0.198 10 false *b 2.458,0.24 2.771,0.438 0.313,0.198 10 false *c
*1 Defogger Wire
*a Tester Probe
*b Aluminum Foil
*c At center


Measure the voltage at the center of each rear window defogger wire to check the wire as shown in the illustration.

Standard:
Voltage Condition
4 to 6 V Wire is not broken
11 to 14 V Wire is broken between the center and ground side end
Below 1 V Wire is broken between the center and battery side end


HINT:

If the voltage is 11 to 14 V, the wire may be faulty between the center of the wire and the wire end on the ground side. If the voltage is below 1 V, the wire may be faulty between the center of the wire and the wire end on the battery side.




d.
B317109
1.417,1.125 1.646,1.271 false 2.063,0.854 2.219,1.063 false 2.094,1.458 2.198,1.188 false 2.844,0.854 3,1.063 false 1.5,1.75 1.667,1.563 false 3.042,1.75 3.208,1.563 false 1.385,1.74 1.698,1.938 0.313,0.198 10 false *e 1.26,1 1.573,1.198 0.313,0.198 10 false *a 1.99,1.479 2.302,1.677 0.313,0.198 10 false *b 1.927,0.688 2.24,0.885 0.313,0.198 10 false *d 2.75,0.688 3.063,0.885 0.313,0.198 10 false *c 2.938,1.75 3.25,1.948 0.313,0.198 10 false *f 0.76,2.906 1.219,3.104 0.458,0.198 10 false (+) 0.781,2.51 1.24,2.708 0.458,0.198 10 false (-)
*a Foil Strip
*b Broken Wire
*c 11 to 14 V
*d Below 1 V
*e Ground Side
*f Battery Side


Place the positive (+) lead of the voltmeter against the rear window defogger wire on the battery side.


e.

Place the negative (-) lead of the voltmeter with the foil strip against the wire on the ground side.


f.

Slide the positive (+) lead from the battery side to the ground side. The point where the voltage drops to below 1 V from 11 to 14 V is the place where the rear window defogger wire is broken.

HINT:

If the rear window defogger wire is not broken, the voltmeter should indicate 11 to 14 V at the battery side. When the positive (+) lead is slid to the ground side, the voltage gradually decreases to below 1 V.



Hide 64811 2.INSPECT BACK WINDOW GLASS

a.

Check the operation.


b.

Check that the indicator illuminates and the rear window defogger becomes warm when the rear defogger switch is pressed.


c.

Check that the indicator turns off and the rear window defogger operation terminates after approximately 15 minutes.