Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID(for LHD)
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092755 BRAKE FLUID(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE FLUID(for LHD)  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


HINT:

If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.


PROCEDURE

Hide 55784B 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER

C286079

a.

Disengage the clip and slide the hood to cowl top seal as shown in the illustration.


b.
C286080

Disengage the 2 claws and 3 guides to remove the center cowl top ventilator louver.


Hide 2.FILL RESERVOIR WITH BRAKE FLUID

a.
C286082

Remove the brake master cylinder reservoir filler cap.


b.

Fill the reservoir with brake fluid.

Fluid:

SAE J1703 or FMVSS No. 116 DOT 3


NOTICE:
·

Do not remove the filter from the brake master cylinder reservoir and be sure to fill the brake master cylinder reservoir with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

·

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.




Hide 3.REPLACE BRAKE FLUID

NOTICE:

Bleed the brake line of the wheel farthest from the brake master cylinder first.


a.
C274982

Connect a vinyl tube to the bleeder plug.


b.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1


c.

At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2


d.

Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.


e.

Tighten the bleeder plug.

Torque:
Front brake : 8.3 N*m (85 kgf*cm, 73 in.*lbf)
Rear brake (for drum type) : 8.5 N*m (87 kgf*cm, 75 in.*lbf)
Rear brake (for disc type) : 11 N*m (112 kgf*cm, 8 ft.*lbf)


f.

Repeat the above procedure to bleed the air out of the brake line for each wheel.


Hide 4.INSPECT FOR BRAKE FLUID LEAK

Hide 5.INSPECT BRAKE FLUID LEVEL IN RESERVOIR

Hide 55784B 6.INSTALL CENTER COWL TOP VENTILATOR LOUVER

a.

Engage the 2 claws and 3 guides to install the center cowl top ventilator louver.


b.
C286081

Engage the clip and slide the hood to cowl top seal as shown in the illustration.