Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD)
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092758 BRAKE BOOSTER(for LHD) G

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE BOOSTER

a.

Airtightness check.

i.
C132722
2.438,0.146 2.896,0.552 0.458,0.406 10 *b 0.635,1.719 1.51,2.063 0.875,0.344 10 *c 0.885,1.625 1.51,1.917 0.625,0.292 10 *d 1.104,1.5 1.604,1.74 0.5,0.24 10 *e 0.802,0.146 1.385,0.458 0.583,0.313 10 *a
*a Correct
*b Incorrect
*c 1st
*d 2nd
*e 3rd


Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.

·

If the pedal can be depressed to the floor the first time, but on the 2nd and 3rd times cannot be depressed as far, the brake booster assembly is airtight. If not, inspect the brake vacuum check valve assembly.

·

If the brake vacuum check valve assembly is normal, replace the brake booster assembly.



ii.

Depress the brake pedal while the engine is running, and stop the engine with the brake pedal depressed.

·

If there is no change in the pedal reserve distance while holding the pedal for 30 seconds, the brake booster assembly is airtight. If not, inspect the brake vacuum check valve assembly.

·

If the brake vacuum check valve assembly is normal, replace the brake booster assembly.




b.

Operation check.

i.
C128542

Depress the brake pedal several times with the engine stopped and check that there is no change in the pedal reserve distance when the pedal is depressed.


ii.
C128543

Depress and hold down the brake pedal, then start the engine.

·

If the pedal goes down slightly, operation is normal. If not, inspect the brake vacuum check valve assembly.

·

If the brake vacuum check valve assembly is normal, replace the brake booster assembly.