Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM SWITCHING VALVE › 2013.08–2016.04
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092760 VACUUM SWITCHING VALVE G

BRAKE SYSTEM (OTHER)  VACUUM SWITCHING VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 25860D 1.INSPECT VACUUM SWITCHING VALVE ASSEMBLY

a.
C282669

Loosen the hose clip and disconnect the No. 2 air hose (connected to the air cleaner) from the vacuum switching valve assembly.


b.

Move the shift lever to P and apply the parking brake.


c.

Connect the GTS to the DLC3, and then turn the ignition switch to ON.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Brake Ejector VSV.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the Brake Ejector VSV
50004 234 173

e.

Start the engine.


f.

Using the GTS, turn off the vacuum switching valve assembly (Brake Ejector VSV: CLOSE).


g.

Use your finger to confirm that the vacuum switching valve assembly has no suction.


h.

Using the GTS, turn on the vacuum switching valve assembly (Brake Ejector VSV: OPEN).


i.

Use your finger to confirm that the vacuum switching valve assembly has suction.


j.

Connect the No. 2 air hose to the vacuum switching valve assembly.