47150
1.INSPECT PROPORTIONING VALVE ASSEMBLY
Remove the bleeder plug from the front brake caliper and rear wheel cylinder.
Install SST and then bleed the air.
Raise the front brake caliper pressure and inspect the rear wheel cylinder pressure.
| Front Brake Caliper Pressure | Rear Wheel Cylinder Pressure |
|---|---|
| 1500 kPa (15.3 kgf/cm2, 218 psi) | 1500 kPa (15.3 kgf/cm2, 218 psi) |
| 5000 kPa (51.0 kgf/cm2, 725 psi) | 2720 kPa (27.7 kgf/cm2, 394 psi) |
| 8000 kPa (81.6 kgf/cm2, 1160 psi) | 3470 kPa (35.4 kgf/cm2, 503 psi) |
If the rear wheel cylinder pressure is incorrect, replace the proportioning valve assembly.
When inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together.
Remove SST.
Install the bleeder plug to the front brake caliper and rear wheel cylinder.
Bleed the brake line.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for LHD)>BLEEDING
Inspect for brake fluid leak.