Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID(for RHD) › 2013.08–2017.10
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092762 BRAKE FLUID(for RHD) N

BRAKE SYSTEM (OTHER)  BRAKE FLUID(for RHD)  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


HINT:

If any work is performed on the brake system or if air in the brake lines is suspected, bleed the air from the brake system.


PROCEDURE

Hide 55784B 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER

Hide 2.FILL RESERVOIR WITH BRAKE FLUID

Hide 47201 3.BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY

NOTICE:
·

To prevent brake fluid from damaging painted surfaces, cover any surrounding parts with a piece of cloth.

·

Be sure to clean your hands before bleeding the brake master cylinder sub-assembly to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.



HINT:

If the brake master cylinder sub-assembly is reinstalled or if the reservoir becomes empty, bleed the air from the brake master cylinder sub-assembly.


a.
C282206

Using a 10 mm union nut wrench, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.


b.
C282207

Slowly depress the brake pedal and hold it there.*1


c.
C282208

Cover the 2 outer holes with fingers and release the brake pedal.*2


d.

Repeat Steps *1 and *2, 3 or 4 times.


e.

Using a 10 mm union nut wrench, connect the 2 brake tubes to the brake master cylinder sub-assembly.

Torque:
15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



Hide 4.BLEED BRAKE LINE

NOTICE:
·

Bleed the brake line of the wheel farthest from the brake master cylinder sub-assembly first.

·

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.



a.
C274982

Connect a vinyl tube to the bleeder plug.


b.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1


c.

At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2


d.

Repeat Steps *1 and *2 until all the air in the fluid is completely bled out.


e.

Tighten the bleeder plug.

Torque:
Front brake : 8.3 N*m (85 kgf*cm, 73 in.*lbf)
Rear brake (for drum type) : 8.5 N*m (87 kgf*cm, 75 in.*lbf)
Rear brake (for disc type) : 11 N*m (112 kgf*cm, 8 ft.*lbf)


f.

Repeat the above procedure to bleed the air out of the brake line for each wheel.


Hide 5.INSPECT FOR BRAKE FLUID LEAK

Hide 6.INSPECT BRAKE FLUID LEVEL IN RESERVOIR

Hide 55784B 7.INSTALL CENTER COWL TOP VENTILATOR LOUVER