Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2013.08–2017.10
RM30M0E _54 Brake _017099 BRAKE SYSTEM (OTHER) _0092764 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 31434C 2.DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)

a.
C282217

Loosen the hose clip and disconnect the clutch reservoir tube from the brake master cylinder sub-assembly.


Hide 47201 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

NOTICE:
·

The brake master cylinder sub-assembly requires careful handling. Do not allow the brake master cylinder sub-assembly to receive any impact, such as from being dropped. Do not reuse a brake master cylinder sub-assembly that has been dropped.

·

Do not pull out the master cylinder piston.

·

Do not strike or pinch the master cylinder piston and do not cause any damage to the master cylinder piston by any other means.

·

When installing the brake master cylinder sub-assembly to the brake booster assembly, or when removing the brake master cylinder sub-assembly from the brake booster assembly, make sure that the brake master cylinder sub-assembly is kept horizontal or with its tip facing downward (the master cylinder piston is facing upward) to prevent the master cylinder piston from falling out.

·

Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the master cylinder piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the master cylinder piston.

·

Do not use any other type of grease or fluid.



a.
C285134

Disconnect the brake fluid level warning switch connector.


b.

Disengage the wire harness clamp.


c.

Using a 10 mm union nut wrench, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.


d.
C285135

Remove the 2 nuts and brake master cylinder sub-assembly from the brake booster assembly.


e.

Remove the O-ring from the brake master cylinder sub-assembly.