Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313A
3.DISCONNECT FRONT FLEXIBLE HOSE
Remove the union bolt and gasket to disconnect the front flexible hose from the front disc brake cylinder assembly.
47750
4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
| *a | Hold |
| *b | Turn |
Hold each front disc brake cylinder slide pin and remove the 2 bolts and front disc brake cylinder assembly from the front disc brake cylinder mounting.
04465
5.REMOVE FRONT DISC BRAKE PAD
Remove the 2 front disc brake pads from the front disc brake cylinder mounting.
04945
6.REMOVE FRONT ANTI SQUEAL SHIM KIT (for Rear Drum Brake)
| *1 | Pad Wear Indicator Plate |
| *2 | Front No. 1 Anti Squeal Shim |
| *3 | Front No. 2 Anti Squeal Shim |
| *4 | Front Disc Brake Pad |
Remove the front No. 1 anti squeal shim and front No. 2 anti squeal shim from each front disc brake pad.
Remove the pad wear indicator plate from each front disc brake pad.
04945
7.REMOVE FRONT ANTI SQUEAL SHIM KIT (for Rear Disc Brake)
| *1 | Pad Wear Indicator Plate |
| *2 | Front No. 1 Anti Squeal Shim |
| *3 | Front No. 2 Anti Squeal Shim |
| *4 | Front Disc Brake Pad |
Remove the front No. 1 anti squeal shim and front No. 2 anti squeal shim from each front disc brake pad.
Remove the pad wear indicator plate from each front disc brake pad.
04947
8.REMOVE FRONT DISC BRAKE FITTING KIT
| *1 | Front No. 1 Disc Brake Pad Support Plate |
| *2 | Front No. 2 Disc Brake Pad Support Plate |
Remove the 2 front No. 1 disc brake pad support plates and 2 front No. 2 disc brake pad support plates from the front disc brake cylinder mounting.
Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.
47715A
9.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.
47769
10.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the front disc brake cylinder slide bush from the front disc brake cylinder slide pin (lower side).
Do not damage the front disc brake cylinder slide pin (lower side).
11.REMOVE FRONT DISC BRAKE BUSH DUST BOOT
Remove the 2 front disc brake bush dust boots from the front disc brake cylinder mounting.
47722
12.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.
43512
13.REMOVE FRONT DISC
| *a | Matchmark |
Put matchmarks on front disc and front axle hub sub-assembly.
Remove the front disc.