Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE CYLINDER BOOT (for Rear Disc Brake)
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the set ring and cylinder boot from the front disc brake cylinder.
Be careful not to damage the front disc brake piston or front disc brake cylinder.
47731
2.REMOVE FRONT DISC BRAKE PISTON (for Rear Drum Brake)
Place a piece of cloth between the front disc brake piston and front disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
Do not place your fingers in front of the front disc brake piston when applying compressed air.
Do not spatter the brake fluid.
Remove the cylinder boot from the front disc brake cylinder.
47731
3.REMOVE FRONT DISC BRAKE PISTON (for Rear Disc Brake)
Place a piece of cloth between the front disc brake piston and front disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
Do not place your fingers in front of the front disc brake piston when applying compressed air.
Do not spatter the brake fluid.
4.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the front disc brake cylinder.
Do not damage the inner surface or piston seal groove of the front disc brake cylinder.
31478B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
Remove the front disc brake bleeder plug cap from the front disc brake bleeder plug.
47547B
6.REMOVE FRONT DISC BRAKE BLEEDER PLUG
Remove the front disc brake bleeder plug from the front disc brake cylinder.