If both LH side front flexible hose and RH side front flexible hose are separated at the same time, be sure to place identification marks indicating the position on each side.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313A
3.REMOVE FRONT FLEXIBLE HOSE (w/ ABS)
Using a 10 mm union nut wrench, disconnect the brake tube from the front flexible hose while holding the front flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.
Remove the clip to separate the front flexible hose from the body.
Remove the bolt to separate the front flexible hose and front speed sensor wire from the front shock absorber assembly.
Remove the union bolt, gasket and front flexible hose from the front disc brake cylinder assembly.
47313A
4.REMOVE FRONT FLEXIBLE HOSE (w/o ABS)
Using a 10 mm union nut wrench, disconnect the brake tube from the front flexible hose while holding the front flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.
Remove the clip to separate the front flexible hose from the body.
Remove the bolt to separate the front flexible hose from the front shock absorber assembly.
Remove the union bolt, gasket and front flexible hose from the front disc brake cylinder assembly.