47831
1.REMOVE REAR DISC BRAKE PISTON
Using SST, remove the rear disc brake piston by turning it counterclockwise.
Do not damage the rear disc brake piston.
Do not allow any brake fluid to spatter.
2.REMOVE CYLINDER BOOT
Remove the cylinder boot from the rear disc brake cylinder.
3.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the rear disc brake cylinder.
Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.
31478C
4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.
47547C
5.REMOVE REAR DISC BRAKE BLEEDER PLUG
Remove the rear disc brake bleeder plug from the rear disc brake cylinder.