Home › Brake › BRAKE (REAR) › REAR BRAKE(for Disc Type)
RM30M0E _54 Brake _017101 BRAKE (REAR) _0092768 REAR BRAKE(for Disc Type) G

BRAKE (REAR)  REAR BRAKE(for Disc Type)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the rear disc brake cylinder bore and rear disc brake piston for rust and scoring. If necessary, replace the rear disc brake cylinder and the rear disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C176438

Using a ruler, measure the rear disc brake pad lining thickness.

Minimum thickness:

1.0 mm (0.0394 in.)


Thickness of new part (Reference):

9.5 mm (0.374 in.)


If the rear disc brake pad lining thickness is less than the minimum thickness, replace the rear disc brake pads.

HINT:

Be sure to check rear disc thickness when replacing the rear disc brake pads with new ones.



Hide 3.INSPECT REAR DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the rear disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are cleaned off.

If necessary, replace the rear disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C283427

Using a micrometer, measure the rear disc thickness.

Minimum thickness:

7.5 mm (0.295 in.)


Thickness of new part (Reference):

9.0 mm (0.354 in.)


If the rear disc thickness is less than the minimum, replace the rear disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the rear axle hub bearing looseness and rear axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB(for Rear Disc Brake)>ON-VEHICLE INSPECTION


b.
C283238C02
1.927,0.906 2.906,0.792 2.906,0.792 1.958,0.969 true 2.938,0.698 3.25,0.854 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks on the rear disc and rear axle hub sub-assembly, and install the rear disc.


c.

Tighten the rear disc with the 4 hub nuts.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


d.
C284312

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the rear disc.

Maximum disc runout:

0.15 mm (0.00591 in.)


If the runout exceeds the maximum value, change the installation position of the rear disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the rear disc. If the rear disc thickness is less than the minimum, replace the rear disc.

NOTICE:

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



e.

Remove the 4 hub nuts and rear disc.