Home › Brake › BRAKE (REAR) › REAR BRAKE(for Drum Type)
RM30M0E _54 Brake _017101 BRAKE (REAR) _0092769 REAR BRAKE(for Drum Type) G

BRAKE (REAR)  REAR BRAKE(for Drum Type)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the rear wheel brake cylinder bore and wheel cylinder piston for rust and scoring. If necessary, replace the rear wheel brake cylinder assembly or wheel cylinder piston.


Hide 2.INSPECT BRAKE DRUM INSIDE DIAMETER

a.
C285306

Using a brake drum gauge or an equivalent tool, measure the inside diameter of the rear brake drum sub-assembly.

Maximum inside diameter:

201 mm (7.91 in.)


Inside diameter of new part (Reference):

200 mm (7.87 in.)


If the inside diameter is more than the maximum, replace the rear brake drum sub-assembly.


Hide 3.INSPECT REAR BRAKE SHOE LINING THICKNESS

a.
F042690

Using a ruler, measure the thickness of the shoe lining.

Minimum thickness:

1.0 mm (0.0394 in.)


Thickness of new part (Reference):

4.0 mm (0.157 in.)


If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the rear brake shoe.

NOTICE:

Always replace both the right and left drum brake shoes together.



Hide 4.INSPECT BRAKE DRUM AND DRUM BRAKE SHOE LINING FOR PROPER CONTACT

a.
C151738

Apply chalk to the inside surface of the rear brake drum sub-assembly, then slide the brake shoe against the drum to check the fit of the brake lining to the rear brake drum sub-assembly.

If the contact between the rear brake drum sub-assembly and the brake shoe lining is improper, repair it using a brake shoe grinder or replace the rear brake shoe.