Home › Brake › BRAKE (REAR) › REAR BRAKE(for Drum Type)
RM30M0E _54 Brake _017101 BRAKE (REAR) _0092769 REAR BRAKE(for Drum Type) A

BRAKE (REAR)  REAR BRAKE(for Drum Type)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL REAR WHEEL CYLINDER KIT

a.
C250558
0,0 3.427,0 false
V100155

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to 2 new wheel cylinder cups and 2 wheel cylinder pistons.


b.
C124866
0.354,1.854 0.354,1.698 false 0.75,1.635 0.75,1.479 false 1,1.563 1,1.406 false 3.167,0.969 3.167,0.813 false 2.781,1 2.781,0.844 false 2.417,1.125 2.417,0.969 false 1.917,1.323 1.917,1.167 false 1.438,1.406 1.438,1.25 false 0.271,1.865 0.427,2.021 0.156,0.156 10 false *1 0.667,1.646 0.823,1.802 0.156,0.156 10 false *2 0.917,1.573 1.073,1.729 0.156,0.156 10 false *3 3.073,0.979 3.229,1.135 0.156,0.156 10 false *1 2.698,1.01 2.854,1.167 0.156,0.156 10 false *2 2.323,1.135 2.479,1.292 0.156,0.156 10 false *3 1.375,1.396 1.531,1.552 0.156,0.156 10 false *4 1.844,1.354 2.156,1.552 0.313,0.198 10 false *5
*1 Wheel Cylinder Boot
*2 Wheel Cylinder Piston
*3 Wheel Cylinder Cup
*4 Rear Wheel Brake Cylinder Compression Spring
*5 Rear Wheel Brake Cylinder


Install the 2 wheel cylinder cups to each wheel cylinder piston.


c.

Install the rear wheel brake cylinder compression spring to the rear wheel brake cylinder.


d.

Install the 2 wheel cylinder pistons to the rear wheel brake cylinder.


e.

Install 2 new wheel cylinder boots to the rear wheel brake cylinder.


Hide 2.TEMPORARILY TIGHTEN REAR DRUM BRAKE BLEEDER PLUG

a.

Install the rear drum brake bleeder plug to the rear wheel brake cylinder.

HINT:

Fully tighten the rear drum brake bleeder plug after bleeding any air left in the system.



Hide 47548R 3.INSTALL REAR DRUM BRAKE BLEEDER PLUG CAP

a.

Install the rear drum brake bleeder plug cap to the rear drum brake bleeder plug.