Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM30M0E _54 Brake _017102 PARKING BRAKE _0092774 PARKING BRAKE SWITCH G

PARKING BRAKE  PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84550 1.INSPECT PARKING BRAKE SWITCH ASSEMBLY

a.

Check the resistance.

i.
C283833
0.531,1.573 0.531,1.24 true 0.135,0.125 0.448,0.281 0.313,0.156 10 false *a 0.5,1.594 0.656,1.792 0.156,0.198 10 false 1
*a Component without harness connected
(Parking Brake Switch Assembly)
V100135

On
V100136

Off


Measure the resistance between the connector terminal and nut inside the parking brake switch assembly.

Standard Resistance
Tester Connection Switch Condition Specified Condition
1 - Switch body Parking brake switch on
(Switch pin free)
Below 1 Ω
Parking brake switch off
(Switch pin pushed in)
10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.