Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT › 2013.08–2017.10
RM30M0E _58 Vehicle Interior _017112 LIGHTING (INT) _0092849 PERSONAL LIGHT G

LIGHTING (INT)  PERSONAL LIGHT  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
E271344
0.5,1.583 1.167,1.417 true 2.792,1.583 2.208,1.417 true 1.417,1.917 1.5,1.5 true 0,0 0.313,0.156 0.313,0.156 10 false *a 0.354,1.49 0.667,1.646 0.313,0.156 10 false E 1.281,1.948 1.594,2.104 0.313,0.156 10 false CTY 2.875,1.49 3.188,1.646 0.313,0.156 10 false B
*a Component without harness connected (Map Light Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (B) - 3 (CTY) DOOR Below 1 Ω
1 (B) - 4 (E) ON Below 1 Ω


If the result is not as specified, replace the map light bulb or map light assembly.



b.

Check the operation.

i.

Slide the switch to the off position.


ii.

Apply battery voltage to the connector and check the map light comes on.

OK:
Battery Connection Switch Condition Specified Condition
Battery positive (+) → 1 (B)
Battery negative (-) → 4 (E)
Drivers switch on Drivers light comes on
Battery positive (+) → 1 (B)
Battery negative (-) → 4 (E)
Drivers switch off Drivers light does not come on
Battery positive (+) → 1 (B)
Battery negative (-) → 4 (E)
Front passengers light switch on Front passengers light comes on
Battery positive (+) → 1 (B)
Battery negative (-) → 4 (E)
Front passengers light switch off Front passengers light does not come on


If the result is not as specified, replace the map light bulb or map light assembly.