Home › Power Source / Network › 2NZ-FE BATTERY / CHARGING › GENERATOR › 2013.08–2016.10
RM30M0E _57 Power Source / Network _017108 2NZ-FE BATTERY / CHARGING _0092353 GENERATOR G

2NZ-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370A 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A310409C01
0.698,0.271 1.01,0.469 0.313,0.198 10 false *a
*a Length


Using a vernier caliper, measure the length of the exposed brushes.

Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed length:

4.5 mm (0.177 in.)


If the exposed length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A310410C01
1.833,1.198 2.292,0.719 2.292,0.719 1.917,1.333 true 2.354,0.604 2.667,0.802 0.313,0.198 10 false *a
*a Slip Ring


Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω


If the result is not as specified, replace the generator rotor assembly.



b.
A310411C01
0.375,0.781 1,0.99 true 1.906,1.917 2.094,1.604 true 1.729,1.844 2.042,2.042 0.313,0.198 10 false *a 0.177,0.688 0.49,0.885 0.313,0.198 10 false *b
*a Slip Ring
*b Rotor


Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor Always 10 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.
A310412

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If the generator rotor bearing does not rotate smoothly, replace the generator rotor assembly.


d.
A310413C01
0.51,0.635 0.823,0.833 0.313,0.198 10 false *a
*a Diameter


Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.


e.
A310414

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.