Home › Drivetrain › C54 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE UNIT(for 2NZ-FE) › 2013.08–2016.10
RM30M0E _52 Drivetrain _017091 C54 MANUAL TRANSMISSION / TRANSAXLE _0094355 MANUAL TRANSAXLE UNIT(for 2NZ-FE) G

C54 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE UNIT(for 2NZ-FE)  INSPECTION  


PROCEDURE

Hide 33369 1.INSPECT NO. 3 SYNCHRONIZER RING

a.
C282950C01
0.635,0.406 0.948,0.563 0.313,0.156 10 false *a
*a Locks and cannot rotate


Check for wear and damage.


b.

Coat the 5th gear cone with gear oil.


c.

Turn the No. 3 synchronizer ring in one direction while pushing it against the 5th gear cone.


d.

Check that the No. 3 synchronizer ring locks.

If the No. 3 synchronizer ring does not lock, replace it.


e.
C282951

Using a feeler gauge, measure the clearance between the No. 3 synchronizer ring and the gear spline end.

Standard clearance:

0.75 to 1.65 mm (0.0296 to 0.0649 in.)


Minimum clearance:

0.75 mm (0.0296 in.)


If the clearance is less than the minimum, replace the No. 3 synchronizer ring.


Hide 33395 2.INSPECT NO. 3 TRANSMISSION HUB SLEEVE

a.
C282952

Check the sliding condition between the No. 3 transmission hub sleeve and the No. 3 transmission clutch hub.


b.

Check that the edges of the No. 3 transmission hub sleeve spline gear are not worn down.


c.
C283213E01
1.438,1.646 1.594,1.844 0.156,0.198 10 false A 2.292,3.875 2.448,4.073 0.156,0.198 10 false B

Using a vernier caliper, measure the width of the No. 3 transmission hub sleeve groove (A) and the thickness of the claw part on the No. 3 gear shift fork (B), and calculate the clearance.

Standard clearance (A - B):

0.3 to 0.5 mm (0.0119 to 0.0196 in.)


If the clearance is not as specified, replace the No. 3 transmission hub sleeve and the No. 3 gear shift fork.


Hide 33336 3.INSPECT 5TH GEAR

a.
C282953

Using a caliper gauge, measure the inside diameter of the 5th gear.

Standard inside diameter:

29.915 to 29.931 mm (1.1778 to 1.1783 in.)


Maximum inside diameter:

29.931 mm (1.1783 in.)


If the inside diameter exceeds the maximum, replace the 5th gear.


Hide 33402 4.INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

a.
C283214

Using a caliper gauge, measure the inside diameter of the reverse idler gear sub-assembly.

Standard inside diameter:

18.040 to 18.058 mm (0.7103 to 0.7109 in.)


Maximum inside diameter:

18.058 mm (0.7109 in.)


If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.


b.

Using a micrometer, measure the outer diameter of the reverse idler gear shaft.

Standard outer diameter:

17.966 to 17.984 mm (0.7074 to 0.7080 in.)


Minimum outer diameter:

17.966 mm (0.7074 in.)


If the outer diameter is less than the minimum, replace the reverse idler gear shaft.