33481X
1.REMOVE SPEEDOMETER DRIVE GEAR
Remove the speedometer drive gear from the front differential case.
41221
2.REMOVE FRONT DIFFERENTIAL RING GEAR
| *a | Matchmark |
Secure the front differential case in a vise between aluminum plates.
Do not overtighten the vise.
Place matchmarks on the front differential ring gear and the front differential case.
Remove the 8 bolts.
Using a plastic hammer, remove the front differential ring gear from the front differential case.
3.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH
Using a dial indicator, measure the front differential side gear backlash while holding the front differential pinion in the front differential case.
0.05 to 0.20 mm (0.00197 to 0.00787 in.)
If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers.
41342A
4.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a 5 mm pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case.
41342F
5.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41331F
6.REMOVE FRONT DIFFERENTIAL SIDE GEAR
Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front differential side gear thrust washers and the 2 front differential side gears from the front differential case.
Rotating each front differential side gear, remove the 2 front differential pinions and the 2 front differential pinion thrust washers.