Home › General › SPECIFICATIONS › 1NZ-FE ENGINE CONTROL › 2013.08–2014.03
RM30M0E _V1 General _017290 SPECIFICATIONS _0096988 1NZ-FE ENGINE CONTROL F

SPECIFICATIONS  1NZ-FE ENGINE CONTROL  SERVICE DATA  


Spark plug standard insulation resistance - 10 MΩ or more
Spark plug electrode gap For new spark plug 0.7 to 0.8 mm (0.0276 to 0.0314 in.)
Spark plug maximum electrode gap For used spark plug 1.1 mm (0.0433 in.)
Camshaft timing oil control valve assembly standard resistance 1 - 2 6.9 to 7.9 Ω at 20 °C (68°F)
Throttle body with motor assembly standard resistance 1 (M-) - 2 (M+) 0.3 to 100 Ω at 20 °C (68°F)
Mass air flow meter standard resistance 1 (THA) - 2 (E2) 13.6 to 18.4 kΩ at -20°C (-4°F)
2.21 to 2.69 kΩ at 20°C (68°F)
0.49 to 0.67 kΩ at 60°C (140°F)
Camshaft position sensor standard resistance 1 - 2 1630 to 2740 Ω at cold
2065 to 3225 Ω at hot
Crankshaft position sensor standard resistance 1 - 2 985 to 1600 Ω at cold
1265 to 1890 Ω at hot
Engine coolant temperature sensor standard resistance 1 - 2 2.32 to 2.59 kΩ at 20°C (68°F)
0.310 to 0.326 kΩ at 80°C (176°F)
Knock sensor standard resistance 1 (EKNK) - 2 (KNK1) 120 to 280 kΩ at 20 °C (68°F)
Heated oxygen sensor (for sensor 1) standard resistance 1 (HT1A) - 2 (+B) 5.3 to 7.5 Ω at 20°C (68°F)
1 (HT1A) - 4 (E2) 10 kΩ or higher
Heated oxygen sensor (for sensor 2) standard resistance 1 (HT1B) - 2 (+B) 11 to 16 Ω at 20°C (68°F)
1 (HT1B) - 4 (E2) 10 kΩ or higher
No. 2 ignition relay standard resistance 3 - 5 10 kΩ or higher
(Battery voltage not applied)
Below 1 Ω
(Battery voltage applied between 1 - 2 terminals)