Home › General › SPECIFICATIONS › 2NZ-FE COOLING › 2013.08–2016.10
RM30M0E _V1 General _017290 SPECIFICATIONS _0096999 2NZ-FE COOLING F

SPECIFICATIONS  2NZ-FE COOLING  SERVICE DATA  


Thermostat Valve opening temperature 80 to 84°C (176 to 183°F)
Valve lift 8.5 mm (0.335 in.) or more at 95°C (203°F)
Cooling fan motor Standard current Positive (+) battery terminal - 2 12.4 to 15.4 A (at 12 V) 20°C (68°F)
Cooling fan resistor Standard resistance 1 - 2 1.17 to 1.43 Ω at 20°C (68°F)
Fan No. 1 Relay Standard resistance 3 - 5 Below 1 Ω (Battery voltage applied to terminals 1 and 2)
10 kΩ or higher (Battery voltage not applied)
Fan No. 2 Relay Standard resistance 3 - 4 Below 1 Ω (Battery voltage not applied to terminals 1 and 2)
10 kΩ or higher (Battery voltage applied to terminals 1 and 2)
3 - 5 10 kΩ or higher (Battery voltage not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage applied to terminals 1 and 2)
Radiator cap sub-assembly Standard valve (for brand-new cap) 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard valve (for after using cap) 78.5 kPa (0.80 kgf/cm2, 11.4 psi)

COOLANT
Capacity Classification
with Fan shroud ventilation duct: 5.0 liters (5.3 US qts, 4.4 Imp. qts)
without Fan shroud ventilation duct: 4.6 liters (4.9 US qts, 4.0 Imp. qts)
Use only "TOYOTA Super Long Life Coolant", or similar high qualityethylene glycol based non-silicate, non-amine, non-nitrite, and nonboratecoolant with long-life hybrid organic acid technology (coolantwith long-life hybrid organic acid technology is a combination of lowphosphates and organic acids).