RM30M0E
_V1
General
_017290
SPECIFICATIONS
_0097003
2NZ-FE STARTING
F
SPECIFICATIONS 2NZ-FE STARTING SERVICE DATA
| Starter assembly
|
Standard current
|
90 A or less at 11.5 V
|
| Starter armature assembly
|
Standard resistance
|
Segment - Segment
|
Below 1Ω
|
| Segment - armature core
|
10 kΩ higher
|
| Circle runout
|
Maximum runout
|
0.05 mm (0.00197 in.)
|
| Commutator
|
Standard diameter
|
28.0 mm (1.102 in.)
|
| Minimum diameter
|
27.0 mm (1.063 in.)
|
| Standard undercut depth
|
0.6 mm (0.0236 in.)
|
| Minimum undercut depth
|
0.2 mm (0.00787 in.)
|
| Starter yoke assembly
|
Standard resistance
|
Field coil brush lead - Terminal C
|
Below 1Ω
|
| Field coil brush lead - Starter yoke body
|
10 kΩ higher
|
| Brush
|
Standard length
|
14 mm (0.551 in.)
|
| Minimum length
|
9 mm (0.354 in.)
|
| Starter brush holder assembly
|
Standard resistance
|
Positive (+) - Negative (-)
|
10 kΩ or higher
|
| Magnet starter switch assembly
|
Standard resistance
|
Terminal 50 - Terminal C
|
Below 1Ω
|
| Terminal 50 - Magnet starter switch body
|
Below 2 Ω
|
| Engine switch
|
Standard resistance
|
5 (SS1) - 6 (AGND)
|
Below 1 Ω (Pushed)
|
| 1 (SS2) - 6 (AGND)
|
| 5 (SS1) - 6 (AGND)
|
10 kΩ or higher (Not pushed)
|
| 1 (SS2) - 6 (AGND)
|
| Ignition or starter switch assembly
|
Standard resistance
|
Between all terminals
|
10 kΩ or higher
|
| 2 (ACC) - 4 (AM1)
|
Below 1 Ω (ACC)
|
| 1 (IG1) - 2 (ACC) - 4 (AM1)
|
Below 1 Ω (ON)
|
| 5 (AM2) - 6 (IG2)
|
| 1 (IG1) - 4 (AM1) - 3 (ST1)
|
Below 1 Ω (START)
|
| 5 (AM2) - 6 (IG2) - 7 (ST2)
|
| Starter relay
|
Standard resistance
|
3 - 5
|
10 kΩ or higher (Battery voltage not applied to terminals 1 and 2)
|
| Below 1 Ω (Battery voltage applied to terminals 1 and 2)
|