Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK(for TMMIN Made) › 2013.12–2018.01
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0105857 FRONT DOOR LOCK(for TMMIN Made) A

DOOR LOCK  FRONT DOOR LOCK(for TMMIN Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION (w/ Power Window)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 69260 4.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74231 5.REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 74231 6.REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 67601 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68171B 8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67831 9.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68101 10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68141C 11.REMOVE FRONT DOOR GLASS RUN

Hide 67403F 12.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 13.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)

Hide 69310 14.REMOVE FRONT DOOR LOCK ASSEMBLY (w/ Power Door Lock)

a.
B359268

Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.

Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.


d.

When reusing the front door lock assembly:

i.
B359270

Remove the door lock wiring harness seal from the front door lock assembly.



Hide 69310 15.REMOVE FRONT DOOR LOCK ASSEMBLY (w/o Power Door Lock)

a.
B365421

Using a T30 "TORX" socket wrench, remove the 3 screws.


b.

Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.


Hide 69710B 16.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Power Door Lock)

a.
B359271

Disengage the guide and remove the front door lock remote control cable assembly from the front door lock assembly.


Hide 69710B 17.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Power Door Lock)

a.
B365422

Disengage the guide and remove the front door lock remote control cable assembly from the front door lock assembly.


Hide 69750C 18.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Power Door Lock)

a.
B359272C01
2.51,2.104 2.146,1.719 true 2.552,2.115 2.865,2.271 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.


b.
B359274

Disengage the guide and remove the front door inside locking cable assembly from the front door lock assembly.


Hide 69750C 19.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Power Door Lock)

a.
B365423

Disengage the guide and remove the front door inside locking cable assembly from the front door lock assembly.