Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK(for TMMIN Made) › 2013.12–2018.01
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0105858 REAR DOOR LOCK(for TMMIN Made) A

DOOR LOCK  REAR DOOR LOCK(for TMMIN Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION (w/ Power Window)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

Hide 69260E 3.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74271A 4.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 74271A 5.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 67603 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68173B 7.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

Hide 68142C 8.REMOVE REAR DOOR GLASS RUN

Hide 67841E 9.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67871 10.DISCONNECT REAR DOOR WEATHERSTRIP

a.

Disconnect the upper part of rear door weatherstrip.


Hide 67407H 11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68103 12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 69330 13.REMOVE REAR DOOR LOCK ASSEMBLY (w/ Power Door Lock)

a.
B359281

Using a T30 "TORX" socket wrench, remove the 3 screws.


b.

Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame sub-assembly.


c.

When reusing the rear door lock assembly:

i.
B359283

Remove the door lock wiring harness seal from the rear door lock assembly.



Hide 69330 14.REMOVE REAR DOOR LOCK ASSEMBLY (w/o Power Door Lock)

a.
B365428

Using a T30 "TORX" socket wrench, remove the 3 screws.


b.

Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame sub-assembly.


Hide 69730D 15.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Power Door Lock)

a.
B365598C01
0.927,1.896 1.49,1.5 true 0.771,1.854 1.083,2.052 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.


b.
B359286

Disengage the guide and remove the rear door lock remote control cable assembly from the rear door lock assembly.


Hide 69730D 16.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Power Door Lock)

a.
B365429

Disengage the guide and remove the rear door lock remote control cable assembly from the rear door lock assembly.


Hide 69770B 17.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Power Door Lock)

a.
B359287C01
1.885,1.792 2.094,2.323 true 2.083,2.333 2.396,2.531 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.


b.
B359289

Disengage the guide and remove the rear door inside locking cable assembly from the rear door lock assembly.


Hide 69770B 18.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Power Door Lock)

a.
B365430

Disengage the guide and remove the rear door inside locking cable assembly from the rear door lock assembly.