Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Pretensioner and Force Limiter).
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
73220
1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
Check the angle of inclination required to lock the retractor.
| *a | Unlock |
| *b | Lock |
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
Do not disassemble the retractor.
If the operation is not as specified, replace the front seat outer belt assembly.
73220
2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Engage the 2 hooks to install the front seat outer belt assembly.
Temporarily install the 2 bolts.
Tighten bolt A and then bolt B.
w/ Pretensioner and Force Limiter:
Connect the seat belt pretensioner connector.
| *A | for TMT Made | *B | for TMMIN Made |
| *1 | Locking Button | - | - |
Lock the locking button.
Securely lock the locking button.
Install the shoulder anchor of the front seat outer belt assembly with the bolt.
Install the floor anchor of the front seat outer belt assembly with the bolt.
Check that the ELR locks.
The check should be performed with the front seat outer belt assembly installed.
Do not allow the anchor of the front seat outer belt assembly and the protruding parts of the floor panel to overlap.
With the belt installed, check that the belt locks when it is pulled out quickly. If the operation is not as specified, replace the front seat outer belt assembly.
Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
62412B
3.INSTALL CENTER PILLAR UPPER GARNISH
62414A
4.INSTALL CENTER PILLAR LOWER GARNISH
73220
5.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Install the floor anchor of the front seat outer belt assembly with the bolt.
62332A
6.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Connect the rear door opening trim weatherstrip.
62312B
7.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Connect the front door opening trim weatherstrip.
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
9.INSPECT SRS WARNING LIGHT (w/ Pretensioner and Force Limiter)