77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
58910C
3.REMOVE REAR CONSOLE BOX ASSEMBLY
57533B
4.REMOVE FRONT FLOOR CENTER BRACE
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58156
6.REMOVE NO. 4 FRONT FLOOR HEAT INSULATOR
Remove the 2 nuts and No. 4 front floor heat insulator from the vehicle.
77641A
7.REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the bolt, clip and No. 1 fuel tank protector from the vehicle.
46420
8.SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts to separate the No. 2 parking brake cable assembly from the vehicle.
77028F
9.DISCONNECT NO. 2 FUEL EMISSION TUBE SUB-ASSEMBLY
Slide the hose clip and disconnect the No. 2 fuel emission tube sub-assembly from the fuel tank to canister tube.
77209F
10.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
| *1 | Retainer |
| *2 | Fuel Tube Connector Cover |
| *3 | Fuel Tube Connector |
| *4 | Fuel Pipe |
| *5 | Nylon Tube |
| *6 | O-ring |
|
Pull |
|
Pinch |
|
Pull Out |
Release the lock of the fuel tube connector cover as shown in the illustration, then pull out the fuel tank main tube sub-assembly.
If the fuel tube connector and fuel main tube are stuck together, push in and pull out the fuel tube connector while squeezing the fuel main tube to release the connection, and then disconnect the fuel tube connector.
Clean away any dirt or foreign matter from the fuel tube connector before performing the operation.
The fuel tube connector and fuel main tube are sealed by O-ring, so be careful to prevent damage to and foreign matter sticking to the contact surfaces.
Do not use any tools.
After disconnecting the fuel tube connector, check that there is no foreign matter on the seal surface of the fuel main tube.
After disconnecting the fuel tank main tube sub-assembly, protect the contact surfaces by covering them with a plastic bag.
Do not bend or twist the tubes.
77701W
11.DISCONNECT NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY
| *1 | No. 6 Fuel Tank Breather Tube |
Disconnect the No. 1 canister outlet hose sub-assembly from the No. 6 fuel tank breather tube.
12.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY
| *1 | Fuel Tank Breather Tube Connector |
Loosen the hose clamp and disconnect the fuel tank breather tube sub-assembly from the fuel tank breather tube connector.
77213B
13.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the hose clamp and disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
77100
14.REMOVE FUEL TANK ASSEMBLY
Using an engine lifter, support the fuel tank assembly.
Remove the 4 bolts and fuel tank assembly from the vehicle.
Make sure that the fuel tank assembly does not fall.
77209F
15.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the 2 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77028F
16.REMOVE NO. 2 FUEL EMISSION TUBE SUB-ASSEMBLY
Disengage the 2 clamps to remove the No. 2 fuel emission tube sub-assembly from the fuel tank assembly.
77701W
17.REMOVE NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY
Disengage the 2 clamps to remove the No. 1 canister outlet hose sub-assembly from the fuel tank assembly.