The ECM constantly generates a 5 V power source voltage from the battery voltage supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power source voltage to the sensors through the VC output circuit.
When the VC circuit is short-circuited, the microprocessor in the ECM and the sensors that are supplied with power through the VC circuit are inactivated because power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.
Under normal conditions, the MIL is illuminated when the ignition switch is turned ON. The MIL goes off when the engine is started.
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.
MIL lights up.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Check for communication between the GTS and ECM.
| Result | Proceed to |
|---|---|
| Communication is not possible | A |
| Communication is possible | B |
A
B
Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>SFI SYSTEM(for Automatic Transaxle)>MIL Circuit
Disconnect the B17 throttle body with motor assembly connector.
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
|---|---|
| MIL does not illuminate | A |
| MIL illuminates | B |
A
B
Disconnect the A33 accelerator pedal sensor assembly connector (for TMT Made).
Disconnect the F85 accelerator pedal sensor assembly connector (for TMMIN Made).
Turn the ignition switch to ON.
Check the MIL.
| Result | Proceed to |
|---|---|
| MIL does not illuminate | A |
| MIL illuminates | B |
A
B
Disconnect the B17 throttle body with motor assembly connector.
Disconnect the A33 accelerator pedal sensor assembly connector (for TMT Made).
Disconnect the F85 accelerator pedal sensor assembly connector (for TMMIN Made).
Disconnect the F83 and B29 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B29-18 (VCTA) - Body ground | Always | 10 kΩ or higher |
| F83-26 (VCPA) - Body ground | Always | 10 kΩ or higher |
| F83-27 (VCP2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG