Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2014.03–2016.04
RM30M0E _58 Vehicle Interior _017115 SUPPLEMENTAL RESTRAINT SYSTEMS _0092017 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 89170A 1.INSTALL AIRBAG ECU ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B344570C01
1.5,1.208 1.542,0.927 false 0.656,0.5 0.969,0.656 0.313,0.156 10 false *a 1.375,1.229 1.781,1.521 0.406,0.292 10 false SST
*a Fulcrum Length


Using SST, install the airbag ECU assembly with the 3 bolts.

SST
09961-00950  

Torque:
without SST : 17.5 N*m (178 kgf*cm, 13 ft.*lbf)
with SST : 11 N*m (112 kgf*cm, 8 ft.*lbf)

NOTICE:
·

Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

·

This torque value is effective when SST is parallel to a torque wrench.

·

If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the ignition switch is first turned to ON after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.




d.
B358377C01
0.854,2.344 1.333,2.021 true 2.219,2.885 2.375,2.521 true 1.375,1.938 1.688,2.135 0.313,0.198 10 false *1 2.125,2.917 2.438,3.115 0.313,0.198 10 false *2
*1 Lever
*2 Waterproof Sheet


Connect the connector holder and lock the lever.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Check that the waterproof sheet is properly set.


f.

Check that there is no looseness in the installation parts of the airbag ECU assembly.


Hide 58910C 2.INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)

Hide 58910C 3.INSTALL REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (for Hatchback)

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION