Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › SFI SYSTEM(for Automatic Transaxle) › 2014.03–2016.10
RM30M0E _51 Engine / Hybrid System _017072 2NZ-FE ENGINE CONTROL _0090867 SFI SYSTEM(for Automatic Transaxle) L

2NZ-FE ENGINE CONTROL  SFI SYSTEM(for Automatic Transaxle)  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).

·

Perform the Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

Click hereDrivetrain>U441E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION

·

Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body with motor assembly components.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION

·

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM.

Click hereEngine / Hybrid System>2NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION

·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System Name See Procedure
Power Door Lock Control System (Click here)




WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.



IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)