Connecting terminals 13 (TC) and 4 (CG) of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light.
When the warning lights continue to blink, a ground short in the wiring of terminal 13(TC) of the DLC3 or an internal ground short in one or more ECUs is suspected.
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| *1 | DLC3 |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F16-13 (TC) - F16-4 (CG) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
A
B
Turn the ignition switch off.
Disconnect the F81*3 or F83*1, *2 ECM connector.
*1: for Automatic Transaxle
*2: for Manual Transaxle with Air Fuel Ratio Sensor
*3: for Manual Transaxle without Air Fuel Ratio Sensor
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-13 (TC) - F83-23 (TC) | Always | Below 1 Ω |
| F16-13 (TC) or F83-23 (TC) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-13 (TC) - F81-6 (TC) | Always | Below 1 Ω |
| F16-13 (TC) or F81-6 (TC) - Body ground | Always | 10 kΩ or higher |
Reconnect the F81*3 or F83*1, *2 ECM connector.
*1: for Automatic Transaxle
*2: for Manual Transaxle with Air Fuel Ratio Sensor
*3: for Manual Transaxle without Air Fuel Ratio Sensor
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-4 (CG) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *1 | DLC3 |
Turn the ignition switch off.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to ON.
Check that the malfunction indicator lamp is blinking.
| Result | Proceed to | |
|---|---|---|
| MIL is blinking | A | |
| MIL is not blinking | 1NZ-FE (for Automatic Transaxle) | B |
| 1NZ-FE (for Manual Transaxle) | C | |
| 1NZ-FE (w/ Air Fuel Ratio Sensor) | D | |
| 2NZ-FE (for Automatic Transaxle) | E | |
| 2NZ-FE (for Manual Transaxle) | F | |
A
B
C
D
E
F