Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR(for Sensor 1) › 2014.03–2016.07
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0116488 AIR FUEL RATIO SENSOR(for Sensor 1) A

1NZ-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A319229C02
1.104,1.875 1.177,1.719 true 0.969,1.885 1.302,2.063 0.333,0.177 10 true SST 0.406,3.052 0.719,3.25 0.313,0.198 10 false *a 1.458,3.052 1.771,3.25 0.313,0.198 10 false *b
*a Fulcrum Length 30 mm
*b Fulcrum Length 300 mm


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the air fuel ratio sensor.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




Hide 17167 2.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.

Install the No. 1 exhaust manifold heat insulator to the exhaust manifold with the 4 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 3.INSTALL WIRE HARNESS CLAMP BRACKET

a.

Install the wire harness clamp bracket to the cylinder head sub-assembly with the bolt.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


b.

Engage the clamp to connect the wire harness to the wire harness clamp bracket.


c.

Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.


d.

Connect the air fuel ratio sensor connector.


Hide 5.INSPECT FOR EXHAUST GAS LEAK