Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
58910C
3.REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
5.LOOSEN PARKING BRAKE CABLE
| *1 | Lock Nut |
Loosen the lock nut and equalizer.
If the lock nut has been removed from the rod, replace the lock nut with a new one.
46430
6.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Disconnect the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.
| *1 | No. 3 Parking Brake Cable Assembly |
| *a | Clip |
Insert a 14 mm offset wrench at the base of the No. 3 parking brake cable assembly as shown in the illustration to disengage the clip, and separate the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.
47319F
7.DISCONNECT REAR FLEXIBLE HOSE
Remove the union bolt and gasket, to disconnect the rear flexible hose from the rear disc brake cylinder assembly.
47850
8.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
| *a | Hold |
| *b | Turn |
Hold each rear disc brake pad guide pin and remove the 2 bolts and rear disc brake cylinder assembly from the rear disc brake cylinder mounting.
04466
9.REMOVE REAR DISC BRAKE PAD
Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.
04946
10.REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT
| *1 | Rear No. 1 Disc Brake Anti Squeal Shim |
| *2 | Rear No. 2 Disc Brake Anti Squeal Shim |
| *3 | Rear Disc Brake Pad |
Remove the rear No. 1 disc brake anti squeal shim and rear No. 2 disc brake anti squeal shim from each rear disc brake pad.
04948
11.REMOVE REAR DISC BRAKE FITTING KIT
| *1 | Rear No. 1 Disc Brake Pad Support Plate |
| *2 | Rear No. 2 Disc Brake Pad Support Plate |
Remove the rear No. 1 disc brake pad support plate and rear No. 2 disc brake pad support plate from the rear disc brake cylinder mounting.
Each rear disc brake pad support plate has a different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that it can be reinstalled to its original position.
47835
12.REMOVE REAR DISC BRAKE PAD GUIDE PIN
Remove the 2 rear disc brake pad guide pins from the rear disc brake cylinder mounting.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the rear disc brake cylinder slide bush from each rear disc brake pad guide pin.
Do not damage the rear disc brake pad guide pin.
47875R
13.REMOVE REAR DISC BRAKE BUSH DUST BOOT
Remove the 2 rear disc brake bush dust boots from the rear disc brake cylinder mounting.
47822
14.REMOVE REAR DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and rear disc brake cylinder mounting from the rear axle beam assembly.
42431
15.REMOVE REAR DISC
| *a | Matchmark |
Put matchmarks on the rear disc and rear axle hub and bearing assembly.
Remove the rear disc.